American Standard 4501 installation instructions Symphony, Threaded Inlets, Entradas Roscadas

	Installation Instructions
	Instrucciones de instalación
SYMPHONY	Mode d’installation
	4 5 0 1

PRESSURE BALANCING BATH AND SHOWER SETS

JUEGOS DE BAÑERA Y DUCHA CON PRESIÓN EQUILIBRADA ENSEMBLES DE BAIN ET DOUCHE À ÉQUILIBRAGE DE PRESSION

Thank you for selecting American-Standard...the benchmark of fine

quality for over 100 years. To ensure that your installation proceeds smoothly-- please read these instructions carefully before you begin.

Gracias por seleccionar los productos American Standard, sinónimo de la mejor calidad durante más de 100 años. Por favor lea estas instrucciones detenidamente antes de comenzar para que lleve a cabo la instalación sin contratiempos.

Nous vous remercions d’avoir choisi American Standard… synonyme de qualité supérieure depuis plus de 100 ans. Pour vous assurer que l’installation se déroulera sans difficulté, veuillez lire attentivement ces instructions avant de commencer.

Certified to comply with ANSI A112.18.1 Cumplimiento certificado de los requisitos de la norma ANSI A112.18.1

Certifié conforme à ANSI A112.18.1

ROUGHING-IN DIMENSIONS DIMENSIONES DE DESBASTADO DIMENSIONS DE PRÉPARATION M968805

To assure proper positioning in relation to wall, note roughing-in dimensions.

Tome nota de las dimensiones de desbastado para asegurar la posición correcta respecto de la pared. Pour garantir un bon positionnement par rapport au mur, tenir compte des dimensions de préparation.

1-5/8" TO 3-1/4"

1-5/8" A 3-1/4" (41 MM A 83 MM)

FINISHED WALL

41 mm (1-5/8 po.) À 83 mm (3-1/4 po.)

3-5/8" REF.

PARED TERMINADA

MUR FINI

1/2" NPT

3-5/8" (92 MM) REF.

RÉF. 92 mm (3-5/8 po.)

1/2" (12,7 MM) NPT

12,7 mm (1/2 po.) NPT

OPTIONAL TO FINISHED

FLOOR USUALLY

BETWEEN 65'' AND 78''

OPTATIVO AL PISO TERMINADO,

POR LO GENERAL ENTRE

65" Y 78" (165 A 198 CM)'

HABITUELLEMENT ENTRE

5-1/2" REF.

165 cm (65 po.)

5-1/2" (140 MM) REF.

ET 198 cm (78 po.)

ENTRE OPTION ET PLANCHER FINI

RÉF. 140 mm (5-1/2 po.)

"SEE ILLUSTRATION "

VEA LA FIGURA INFERIOR

VOIR INSTALLATION CI-DESSOUS

74" FOR HEAD CLEARANCE

74" (188 CM) DE ALTURA

188 cm (74 po.) POUR DÉGAGER LA TÊTE

6-3/4"

6-3/4" (172 MM)

172 mm (6-3/4po.)

18" OPTIONAL

18" (45,7 CM) OPTATIVO

OPTION 45,7 cm (18 po.)

3-5/8"

3-5/8" (92 MM)

92 mm (3-5/8 po.)

1/2" NPT''

4"

5-1/8" REF.

O 1/2" (12,7 MM) NPT''

4" (102 MM)

5-1/8" (130 MM) REF.

OU NPT 12,7 mm (1/2 po.)

102 mm (4 po.)

RÉF. 130 mm (5-1/8 po.)

TOP OF TUB RIM

BORDE SUPERIOR DE LA BAÑERA

HAUT DE REBORD DE BAIGNOIRE

BOTTOM OF TUB

FONDO DE LA BAÑERA

FOND DE BAIGNOIRE

		INLETS 3-3/8"
		ENTRADAS, 3-3/8" (86 MM)
		ENTRÉES 86 mm (3-3/8 po.)
		SHR. 1/2" NPT
		DUCHA, 1/2" (12,7 MM) NPT
3-3/8"		DOUCHE NPT 12,7 mm (1/2 po.)
		INLETS 1/2" NPT
3-3/8" (86 MM)
86 mm (3-3/8 po.)		ENTRADAS, 1/2" (12,7 MM) NPT
TUB PORT 1/2" NPT'		ENTRÉES NPT 12,7 mm (1/2 po.)
	THREADED INLETS
ORIFICIO DE BAÑERA,
1/2" (12,7 MM) NPT'	ENTRADAS ROSCADAS
ORIFICE BAIGNOIRE NPT
12,7 mm (1/2 po.)	ENTRÉES FILETÉES

1	ROUGHING-IN		1
		CAUTION
			Turn off water at main supply.

When soldering, remove PLASTER GUARD and CARTRIDGE. When finished soldering, flush valve body, NOTE replace cartridge and plaster guard to continue installation. Use thread sealant or Teflon tape on

threaded connections.

		If the valve is installed on a fiberglass		2
See Roughing-in diagram before starting.		or other thin wall application, the
		PLASTER GUARD (4) can be used as a support.
Connect RISER PIPE (1) to MANIFOLD (2)
			Cut a 3" dia. hole in the shower stall.
top outlet marked "SHR".			Remove PLASTER GUARD (4), rotate 90 degrees	HOT
Connect TUB FILLER PIPE (3) at bottom			so that indicated screw holes fit MANIFOLD (2).	CALIENTE
outlet marked "TUB".			Push CAP on valve, place ESCUTCHEON on and	CHAUD
Supply connections are:			attach with screws.
	1/2" female NPT for threaded inlets	Connect hot and cold water supplies.
For proper positioning the finished wall		Cap off shower pipe (5) and tub filler pipe (6).
must be within side wall of PLASTER		For support, use pipe BRACES (7) secured to wooden
GUARD (4).		braces.
		With valve turned off, turn on water supplies.
		Check for leaks.

5

7

COLD

FRÍA 4 FROID

3

6