American Standard 4962.151, 4962.150 Test Installed Faucet Check for Leaks

4	TEST INSTALLED FAUCET	1
	AND CHECK FOR LEAKS

With HANDLE (1) in OFF position, turn on WATER

SUPPLIES (2) and check all connections for leaks.

3

Remove AERATOR (3).

Operate HANDLE (1) to flush water lines thoroughly.

Replace AERATOR (3).

HOT

COLD

5 HOT LIMIT SAFETY STOP ADJUSTMENT

By restricting handle rotation and limiting the amount of hot water allowed
to mix with the cold, the HOT LIMIT SAFETY STOP reduces risk of accidental
scalding. To set the maximum hot water temperature of your faucets, all you
need to do is adjust the setting on the HOT LIMIT SAFETY STOP	.
Loosen SET SCREW (2) with 2.5mm hex wrench. Pull HANDLE (1) off valve
stem. Pull off CAP (3). Use a flat blade screwdriver or your fingers to pull up
and rotate red HOT LIMIT SAFETY STOP (4). Follow Step "A" or "B" to adjust
min./max. discharge temperature. "0" being the hottest to "7" the coldest
temperature setting. Factory set at "0".

Replace ESCUTCHEON CAP (3), HANDLE (1), tighten

HANDLE SCREW (2).5&.1&3"563& 4&55*/(
/6.#&34

"B"

PRY RED RING FORWARD
AND ROTATE CLOCKWISE	"B"
"B"
ADJUSTMENT WHEN
WATER IS TOO COLD

2

1

2

3

"A"

PRY RED RING FORWARD

AND ROTATE COUNTER-

CLOCKWISE ONE CLICK

						"A"
						"A"
						ADJUSTMENT WHEN
			
						WATER IS TOO HOT





4

3&%
3*/(
)05

-*.*5
4"'&5:
4501

6 CARE INSTRUCTIONS:

To keep your new faucet looking new, please follow these simple care instructions:

DO:	Simply rinse the faucet clean with clear water.
	Dry the faucet with a soft cotton cloth.

DO NOT:

Do not use any abrasive cleaners, cloths, or paper towels.

Do not use any cleaning agents containing

acids, polish abrasives, or harsh cleaners or soaps.

Regular and routine cleaning will reduce the need for heavy cleaning and polishing. If heavy cleaning is required, the following procedures are recommended:

Remove as much surface dirt and film using clear water and soft cotton cloth (as described above).

Use any of the following to remove tough surface film and build-up:

Mild liquid detergents

Clear ammonia free liquid glass cleaners Non-acidic, non-abrasive gentle liquid or fully dissolved powder cleansers mixed according to manufacturers directions.

Non-abrasive liquid polishers

Once clean, rinse faucet again with clear water to thoroughly remove cleaner or polish and blot dry with a soft cotton cloth.

Failure to follow these care instructions may damage the Faucet's finish.

M 9 6 8 8 4 7