3
A)Apply a bead of tub surround adhesive down each stud that will come in contact with the back panel being sure to stay below the line you marked. You do not need to apply adhesive to the corner studs.
B)Lay a bead of silicone caulk along tub ledge.
C)Reposition back panel aligned with pencil line and press firmly against studs.
Pencil line
Tub Surround Adhesive 
bead
Silicone
Sealant
4A) • Locate and drill a clearance hole in the center of the top nailing flange and centered on each stud (see arrows as shown).
•Also drill four evenly spaced clearance holes on the front nailing flange on each side (see arrows as shown).
B)Ensuring mating surface is square and plum (Fig. 2), install galvanized screws through each clearance hole and into the studs, securing the wall panel.
C)Add a bead of silicone caulk down the vertical corner of the back panel (Fig. 2).
Drill clearance | Stud |
hole for screw |
|
in top |
|
nailing |
|
flange |
|
Mating surface
(square and plum)
Drill clearance hole for screw in front nailing flange
Drill clearance holes for screws
Silicone 
Sealant
Fig. 2
4 | 753846 - 100 Rev . C |
