American Standard 6054.XXX Install POP-UP Drain, Install Black Gasket, Install Gray Locknut

2 INSTALL POP-UP DRAIN	Fig. A.	Fig. B.
Remove CLEAR PLASTIC COVER (1). Remove	1
CARDBOARD SPACER (2) from under DRAIN			REAR OF
POP-UP (3). Fig. A.	3		SINK
Drop DRAIN BODY (4) through sink drain			4
hole. Make sure WHITE FOAM GASKET (5)
			6
is under flange of DRAIN BODY (4). Fig. B.		5
Note: No plumber’s putty or caulk is required.	2		SINK
The CABLE ATTACHMENT POINT (6) must			DRAIN
			HOLE
face towards the rear of the SINK. Fig. B.
3 INSTALL BLACK GASKET
Install BLACK CONE GASKET (1) onto DRAIN BODY (2)
from below.
Note: The flat side of the BLACK CONE GASKET (1) must
face down.		2

			1
			FLAT SIDE OF GASKET
			MUST FACE DOWN
4 INSTALL GRAY LOCKNUT	Fig. A.		Fig. B.
Install GRAY LOCKNUT (1) onto DRAIN BODY (2)
from below SINK. Fig. A.
Note: The flat side of the GRAY LOCKNUT (1)
must face up.		2
Tighten firmly by hand. No tools are required.				DRAIN
Check DRAIN FLANGE in SINK to ensure that			FLAT SIDE OF	FLANGE
WHITE FOAM GASKET (3) is fully compressed
and not visible. Fig. B.			GRAY LOCKNUT
			MUST FACE UP
		1	3	WHITE FOAM
				GASKET
				NOT VISIBLE
5 POP-UP KNOB				DOWN
POP-UP KNOB (1) must be fully down.				1

M 9 6 8 6 3 2

UP

2