General Information
Door Removal (30”W.)
Installation (30”W.) 1
NOTICE
READ AND FOLLOW ALL WARNING AND CAUTION INFORMATION WHEN INSTALLING THIS APPLIANCE.
•All openings in the wall behind the appliance or in the floor under the appliance should be sealed.
•Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors.
•Disconnect the electrical supply prior to servicing or cleaning.
•When removing the appliance for cleaning or service, disconnect AC power supply and carefully remove the appliance by pulling forward.
•Electrical requirements are listed in the product specifications under the “Electrical
&Gas Requirements” section.
•Do not obstruct the flow of combustion and ventilation air.
Moving, Handling, and Unpacking
Remove and discard all packing materials, including cardboard and tape on the outside and inside of the ovens.
Some stainless steel parts may have a plastic protective wrap which must be peeled off. The interior should be washed thoroughly with hot, soapy water to remove film residues and any dust or debris before being used, then rinsed and wiped dry. Solutions stronger than soap and water are rarely needed.
Recommendations for Unpacking
•Products are shipped on pallets with foam footings and corrugated
•Products are anchored to the pallet using metal straps that are screwed to the bottom of the product and the pallet.
•DO NOT remove protective packaging until you are ready to perform the installation.
•To remove the packaging, first remove the staples located at the bottom perimeter of the corrugated cover.
•Remove the corrugated cover by lifting it off the product and remove the inner- packing.
•Detach the product from the metal anchor strip by removing the attachment screw.
Recommendations for Moving
•The appliance is heavy – use extreme care when handling!
NOTICE
DO NOT use the handle or oven door to lift the oven. Remove door before installation to ensure that it is not used to lift the unit. DO NOT lift or carry the door by the handle.
Removing the door must be done by your dealer, a qualified licensed plumber, or certified gas installer.
•Only proper equipment should be used to move products.
•ALWAYS take steps to protect flooring at the installation location when moving products.
DO NOT use the handle or oven door to lift the oven. Remove door before installation to ensure that it is not used to lift the unit. DO NOT lift or carry the door by the handle.
Removingthe door must be done by your dealer, a qualified licensed plumber, or certified gas installer.
Remove wooden brace on front of pallet.
2 | 3 |
| 2 |
1 | 2 |
| 1 |
| 2 |
Open door completely. Place pin in pin hole. | Remove hinge trim screws. Take off hinge trim. |
Note: Two pins included. |
|
4 | 5 |
Close until pins stop door. | Lift door up and out. |
| Note: Do not lift door using handle. |
14 | 15 |
