![](/images/new-backgrounds/1061867/6186717x1.webp)
Connecting Gas & Electrical (30”W.)
Final Installation (30”W.)
1 | 2 |
DANGER
Gas leak hazard.
To avoid risk of personal injury or death; leak testing of the appliance must be conducted
according to the manufacturer’s instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution.
• DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.
WARNING
Electrical shock hazard.
To avoid the risk of electrical
shock, personal injury or death; verify your appliance has been
properly grounded in accordance with local codes or in absence of codes, with the National Electrical Code (NEC). ANSI/NFPA
Remove racks. | Unscrew pallet screws from side of oven. |
1
Note: Refer to “Electrical & Gas Requirements” section for proper installation information.
Connect gas and electrical. Before placing appliance in operation, always check for gas leaks. This must be performed by your dealer, a qualified licensed plumber, or gas service company.
3 | 4 |
Lift oven into position. | Push oven straight into cabinet. |
5 | 6 |
Attach screws to the side of the framing. | Replace racks. |
Note: Four screws (two on each side). |
|
(Screws not included.) |
|
16 | 17 |