3HOW TO SET DEFAULT TEMPERATURE Fig. 3
Note: The factory setting of the Default Temperature is at a position of even amounts of hot and cold water flows. This setting can only be changed within the first 15 minutes of switching on the power.
1.Remove the power to the faucet by unplugging the Power Supply from the wall outlet. Wait 60 seconds, and then plug the Power Supply Back into the wall outlet.
2 . Place hand in front of Blue (Cold) Sensor until the Blue LED lights up. Fig. 3.
Fig..23 |
| Fig. 3a | ADJUST HOT |
|
| ||
ADJUST |
| RED SENSOR | |
COLD |
| ||
BLUE |
| ||
| SENSOR |
| |
3. Within the next 5 seconds, start the faucet water flow |
by placing hand within the On/Off Sensor range. Fig. 3. |
4. Adjust the output faucet temperature by using the |
Red (Hot) Sensor to increase, or Blue (Cold) Sensor to |
decrease. During this process always keep your hand |
within The On/Off Sensor range in order to feel the |
change water temperature. Fig. 3, Fig. 3a. |
5. Once desired temperature has been set, remove |
hands away from the range of sensors. Water flow will |
stop and both Red and Blue sensors will |
seconds indicating the default temperature has been set. |
6. The Default Temperature has been set. This will |
remain the default setting untill the setting is changed |
Fig. 1
1
Fig. 1a
3
24
5
6
again. If power is lost, this will remain the default |
setting. |
Note: The Default Setting is actually a mechanical positioning of a mixing valve. Changes in the supply temperatures will create changes to the Default Temperature.
MAINTENANCE
1HOW TO REMOVE MIXING VALVE Fig. 1
1.Remove four screws and pull off ENCLOUSURE COVER (1). Fig. 1.
2.Remove MOTOR GEAR COVER (2) by pulling off or pry off with a
3.Remove SCREW (3) from the center of the LARGE GEAR (4) and two SCREWS (5) from the MOTOR HOUSING (6). Fig. 1a.
4.Pull of MOTOR HOUSING (6) with LARGE GEAR
(4) from the MIXING VALVE STEM (7). Fig. 1b.
5.Remove LOCKNUT (8) from the MIXING VALVE HOUSING (9) using adjustable wrench. Fig. 1c.
6.Pull out MIXING VALVE (10). Use pliers if necessary.
Fig. 1d.
7.Reverse above steps for assembly.
Fig. 1b | 6 |
7
Fig. 1c
INSTALL
REMOVE
8
9
Fig. 1d
10
6 | M968857 REV. 1. 2 |
