American Standard 6074.XXX 9TEST INSTALLED FITTING, Check Drain Connections, Service

9TEST INSTALLED FITTING

With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.

Remove AERATOR HOUSING (6). (Turn counter-clockwise). Remove AERATOR INSERT (3) from AERATOR HOUSING (6).

Operate both HANDLES (1) to flush water lines thoroughly.

Replace AERATOR (3) and AERATOR HOUSING (6).

CHECK DRAIN CONNECTIONS

Operate POP-UP KNOB (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in SINK. If DRAIN STOPPER (5) does not seal properly, please refer to Troubleshooting section in these instructions.

Release POP-UP KNOB (5) down and check all drain connections and "P" trap for leaks. Tighten

if necessary.

3 6

1 REMOVE

4

5

WASTE

OUTLET

	2		2
			“P” TRAP
10 SERVICE		1
To change direction of handle		2
rotation, proceed as follows:
Turn VALVE to OFF position. Pull out INDEX BUTTON (1).	3
Remove HANDLE SCREW (2), and pull HANDLE (3) off of
ADAPTOR (4).
Pull ADAPTOR (4) off VALVE STEM (5) and turn 90˚ in a way that
flat in ADAPTOR (4) catches a different flat on VALVE STEM (5).
Reinstall ADAPTER (4), HANDLE (3) and HANDLE SCREW (2).		4
Push in INDEX BUTTON (1).
AERATOR (6) may accumulate dirt causing distorted and reduced		90˚	6
water flow. Remove AERATOR (6) and rinse clean. See step 9 above.
If Faucet Drips Proceed As Follows:		5
Turn VALVE in OFF position.		FLAT

If spout drips, operate HANDLES (1) several times from

OFF to ON position. Do not force-handles turn only 90˚.

11 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

M 9 6 8 6 3 3

4