American Standard 730431-100 Install Mounting Hardware, For Marble Or Solid Surfaces, For Wood

2

Perimeter of lavatory

1-1/2"

Cutout

Cut opening 1-1/2" inside the perimeter line

of the lavatory.

6	After checking fit and
	alignment of lavatory to cut
	out, apply a bead of silicone
	adhesive to rim of lavatory.

3 LOCATION OF MOUNTING HOLES

45˚ LOCATION OF CLIPS

On underside of countertop, locate mounting hardware holes as shown 1-7/8" outside of cutout.

1-7/8" TYP.-4 PLACES

7	Center bowl over cutout and tighten
	screws (see 4) to secure bowl to
	countertop. Remove excess sealant
	from inside lip.
8	Install faucet (not included)
	and countertop (not included)
	following manufacturers

4	INSTALL MOUNTING HARDWARE
	FOR MARBLE OR SOLID SURFACES	FOR WOOD
	Drill 3/8 Dia .X 1/2 deep hole

instructions.

3/4 MIN.	Brass insert, epoxy	3/4 MIN.
	in place with threaded
	end exposed. (Epoxy
	not supplied).
	Clip	Clip
	#10-24 Mach. screw	Drill 1/8 dia. X 3/8 deep
		#10 Wood Screw

9

Connect supply line to faucet (finger tight) and carefully bend tubes to engage with the supply shut-off valves. Tighten connections at faucet and shut-off valves for water tight seal.

5

Mount the drain assembly (not included) on the lavatory, following faucet

Shut-Off Valves

A

manufacturer's instructions. Be certain to apply a bead of sealing putty on the underside of the drain (Part "A") in order to ensure a watertight seal between the lavatory and drain. Remove excess putty after installing drain on lavatory.

10

C

B

Connect trap to drain assembly hand tight to check alignment. It may be necessary to cut off part of the tailpiece (area "B") or part of the horizontal leg of the trap (area "C"). Secure joints for watertight assembly.

730431-100