7 ATTACH CABLE CONNECTOR
Thread CABLE CONNECTOR (1) clockwise onto DRAIN BODY CONNECTION (2) and hand tighten. Fig. A.
Your new
Note: Tailpeice on
Fig. B.
Fig. A.
1
2
Fig. B.
8 CHECK OPERATION OF POP-UP
Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes.
Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions.
1
2
9 MAKE WATER SUPPLY AND WASTE CONNECTIONS
Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left SUPPLY (1) to Hot (Marked with a Red Band) and right supply to COLD (2) wall supply.
Faucet supplies are 20" long from faucet base.
Note: If additional supply length is required, installer must purchase additional parts separately.
Important: If SUPPLY HOSES (1, 2) are to long, loop as |
| |
illustrated to avoid kinking. |
| |
Connect | APPROX. 20" | |
waste outlet. | ||
|
|
| 2 |
1 | RED | BLUE |
BAND |
BAND
3/8" COMPRESSION
HOT COLD
M 9 6 8 8 8 9 Rev. 1 . 2
3