Ameriphone CL-40 Getting Started (continued)

Getting Started (continued)

6.Raise or reposition the antenna on the base unit for the best reception.

7.We recommend not placing this unit next to appliances. Doing so may cause

interference.

8.TONE/PULSE Select Switch:

A.If your home is equipped with a Tone dialing system, set the TONE/PULSE

select switch to the TONE position.

B.If you have a rotary dialing system, set the TONE/PULSE select switch to

PULSE position.

C.If you are unsure which system you have, set the TONE/PULSE select switch

to the TONE position. Press the TALK button on the handset to get a dial tone,

and press any key on the keypad except the zero. If the dial tone continues,

it means that you do not have Touchtone dialing service. Press the TALK

button on the handset to hang up. Set the TONE/PULSE select switch to the

PULSE mode and then try again.

9. Before initial use, charge the handset for 12 hours.

MANUAL(430-0102-)V3.p65 02-10-23, 11:3010

Contents

Main Operating Instructions CL Contents IMPORTANT SAFETY INSTRUCTIONS ADDITIONAL SAFETY NOTES FOR CANADIAN USERS 4 SAVE THESE INSTRUCTIONS Battery Cautionary Instructions CAUTION: To reduce the risk of fire or personal injury, read and follow these instructions: ATTENTION: Page HANDSET Controls Page BASE UNIT Controls Getting Started Connecting Your Phone Getting Started (continued) 11 Desk Mounting Desk Mounting FIGURE 1 Wall Mounting Wall Mounting Receiving Calls when the handset is in the base unit Receiving Calls when the handset is NOT IN the Base Unit Automatic Amplifier Setting Page Placing Calls Handset REDIAL Feature Using the Headset Feature Note: Direct Audio Connection To assistive listening device Storing Numbers Recalling Stored Numbers from Memory Security Security Security Code Multi-Channel Access Recharging the Battery Pack Battery Type Recharging the Battery Pack Changing the Battery Pack To Replace the Battery Pack: Changing the Battery Pack Remove the handset battery compartment cover by pressing the circular on the top side of the cover then silde it down. Problem Solving Section Problem Solving Technical Information Noise Range Interference Technical Information Federal Communications Commission Requirements FCC Requirements Federal Communications Commission Requirements (continued)