16
5200 User’s Manual
Basic Operation and Menu Navigation
Power Up The AmPro 5200 Series follows an initial “power-up” sequence from the time the main AC is
toggled “on” to the time an image is displayed.
With the two receivers installed, plug the main power cord into a receptacle.
Toggle the main ac switch “on”. The projector will automatically start, first displaying the
Windows boot-up screen, then the Scan Disk operation.
The projector will then automatically search for an external source, if present, the
projector will perform an auto-setup, then display the source. If no source is present, the
projector will automatically switch to the internal graphic channel.

NOTE: If more then one external source is present, the projector will switch to the “last

source” selected prior to the last shutdown.

Lens Focus /
Shift / Zoom There are two knobs located directly below the lens assembly. The knob on the left (as
viewed from the front, table mounted) is used to perform the lens shift, while the second knob
is used for lens focus. Adjust the Shift/Focus knobs for optimal picture performance. If your
projector is equipped with a zoom lens, adjust the image size using the gray ring around the
lens.
On-Screen
Menus The AmPro 5200 uses a series of overlay menus to control the operation of the projector.
Meaning, whatever source is currently being displayed, the control menu and commands are
overlaid on top of it. This technique allows the user to utilize the controls of the projector and
make desired changes while the active source is being used.
To bring-up the main menu, press on the remote control or <Enter> on the keyboard.
Below illustrates and briefly explains the main command set options.
Picture – Allows the user to adjust image quality functions such as, brightness, contrast,
clock phase and some advance settings as well.
Source – Allows the user to explicitly select the display source type. I.E., RGB, RGB2,
VIDEO etc.
Setup Wizard – The Setup Wizard allows the user to step through predetermine setup
sequence. This is useful for the first time user.
User Menu– This function allows you to perform a random type of channel setup or
editing. Experience operators typically use this function.
Menu – Menu presents additional commands and functions for the setup of a source
(channel).
Chan 1: Sel Channel – This button displays the currently active channel. Once selected,
a channel list dialog box is presented for manual selection of a desired channel setup.
Standby – Puts the projector into the standby mode. Powers the lamp supply off. Press
the center of the Mouse Pad (remote) or <Enter> (keyboard) to redisplay the image.
Also, see Remote Control operation.
Power – Powers the projector (Display engine/Lamp) OFF. Presents the user with a
decision dialog box. In the event this command was entered intentionally, simply select
NO on dialog box.
Help – Enters the internal WinHelp help f ile.
Exit - Exits the menu system and removes the menu(s) from the screen.