AMX AXB-DTMF+ Sendcommand DTMF, EXTEN-OFF, Sendcommand DTMF, EXTEN-ON, Sendcommand DTMF, Flash

Programming

Operative System Send_Commands (Cont.)

Command	Description
DIAL-X-XXX-XXXX	Dial number and send DTMF.
	• Spaces or hyphens are ignored when dialing.
	• A 'W' in the dial command will cause the AXB-DTMF+ to wait for dial tone
	before dialing the next digit in the dial command. The wait will time out after 2
	seconds. If a time out occurs, the AXB-DTMF+ will indicate this by sending a
	push and release on channel 45.
	• A ',' in the Dial command will cause the AXB-DTMF+ to pause for a time
	specified in the Pause Send_Command before dialing the next digit in the
	command.
	Example:
	SEND_COMMAND DTMF, 'DIAL-9 W 214,644-3048'
	Causes the AXB-DTMF+ to dial a 9 and then waits for dial tone before continu-
	ing to dial the next three digits. The AXB-DTMF+ pauses for the time specified
	in the Pause Send_Command before dialing the remaining six digits.
	Up to 24 characters following Dial are allowed. Characters that generate tones
	are 0 - 9, *, #, A - D.
	Note: Tone length is set by the Tone Time Send_Command which sets the
	length of each generated tone and the time between tones. A pause can be
	added after a tone, for additional dial time, by using the Pause
	Send_Command. For more information refer to the 'TONE TIME-XXX ' and
	'PAUSE-XXX ' Send_Commands.
EXTEN-OFF	Disable phones which are hanging off the extension phone connection on the
	AXB-DTMF+ by opening the phone circuit.
	Default at reset = NO
	Example:
	SEND_COMMAND DTMF, 'EXTEN-OFF'
	Disables phones that are hanging off the extension phone connection on the
	AXB-DTMF+ by opening the phone circuit.
EXTEN-ON	Enable phones that are hanging off the extension phone connection on the
	AXB-DTMF+ by closing the phone circuit.
	Default at reset = YES
	Example:
	SEND_COMMAND DTMF, 'EXTEN-ON'
	Enables any phones that are hanging off the extension phone connection on
	the AXB-DTMF+ by closing the phone circuit.
FLASH	Cause flash-hook for a period of time set by the Send_Command FLASH
	TIME.
	Example:
	SEND_COMMAND DTMF, 'FLASH'
	Causes flash-hook for a period of time set by the Send_Command FLASH
	TIME.
'OFF HOOK	Place AXB-DTMF+ off hook.
	Default at reset = NO
	Example:
	SEND_COMMAND DTMF, 'OFF HOOK'
	Places the AXB-DTMF+ off hook.

AXB-DTMF+ DTMF+ Interface 9