AMX AXB-DTMF+ instruction manual Minute after call termination

		Programming
Channel Codes (Cont.)
Operation	Channel #	Description (ON Indicates)
Detection (Cont.)	39	Indicates a momentary loss of loop current (call termination).
		Call Progress Reporting returned to the Axcess AXC-EM when
		call termination is detected.
		Detection of call termination (other end hung up) is usually pro-
		vided by the telephone company and is activated by a momentary
		loss of loop current. However, if this is not available, the DTMF+ is
		triggered by the receiver off-hook tone which occurs approximately
		1 minute after call termination.
	40	Indicates receiver off-hook tone.
		Call Progress Reporting returned to the Axcess AXC-EM when a
		receiver off-hook is detected.
	45	Indicates time out while waiting for the dial tone during a wait (W)
		in the Dial Send_Command.
	47	Indicates dial tone presence.
Distinctive Ring	41-44	The AXB-DTMF+ provides report capability for the type of ring
		received. Distinctive ringing is a service that must be obtained
		from the telephone company. This service allows the same tele-
		phone line to be reached by dialing different telephone numbers.
		The receiving telephone then rings in a distinctive manner accord-
		ing to the number dialed.
		The AXB-DTMF+ provides 4 distinctive ring type patterns.
		These default patterns can be changed and are as follows:
	41	Default Pattern 1
		The first ring lasts 2 seconds followed by 4 seconds of silence.
	42	Default Pattern 2
		There are 2 long rings in a 2 second period followed by 4 seconds
		of silence.
	43	Default Pattern 3
		There are 2 short then 1 long ring in a 2 second period followed by
		4 seconds of silence.
	44	Default Pattern 4
		There is 1 short, 1 long, and 1 short ring within a 2 second period
		followed by 4 seconds of silence.

AXB-DTMF+ DTMF+ Interface 23