AMX AXC-232++ instruction manual Baud rates 300, 600, 1200 , 4800, 9600, 19200

Introduction

Specifications (Cont.)

LEDs:
RX/TX:	Red LED indicators for data transmission
RX:	Red LED blinks to indicate that the AXC-232++ is receiving RS-232,
	RS-422, or RS-485 data.
TX:	Red LED blinks to indicate that the AXC-232++ is sending RS-232,	RS-
	422, or RS-485 data.
DIP Switch	8-position RS-232/422DIP switch.
	See Setting the RS-232/422 DIP Switch section on page 4 for configuration
	details.
Asynchronous data	• Baud rates - 300, 600, 1200. 2400, 4800, 9600, 19200 and 38400.
standards	57600 is supported via the BAUDMED Send Command (see
	Send_Commands section on page 9 for details).
	115200 is supported via the BAUDHIGH Send Command (see the
	Send_Commands section on page 9 for details).
	• Data bits - 7, 8, and 9
	• Stop bits - 1 and 2
	• Parity - None, Odd, Even, Mark and Space
Connectors:
• RS-232	Hardware handshaking (RTS/CTS) data control jack (3-pin male)
• RS-422	RS-232/422 data control jack (4-pin male)
• +12VDC	Auxiliary power jack (1-pin male)
• RS-232	RS-232 data control jack (3-pin male)
• AXlink	AXlink bus jack (4-pin male)
Buffer	• 1000 byte input buffer
	• 1000 byte AXlink buffer
Internal jumpers	Sets differential input termination to enable RS-485 output.
Processor	32-bit processor
Memory	384K of non-volatile memory (memory runs Axcess programs independent of
	the master program. This relieves the AXlink bus and the master of the pro-
	cessing time for controlling those devices; requires Axcess version 3.0 or
	higher).

2 AXC-232++ RS-232/422/485 Interface Card