AMX NXC-ME260 - page 30

Firmware Transfers

26 NXC-ME260 NetLinx Master-Ethernet Card/Module

4. Review the File, Connection, Address, and Target Device information before you send.

! Check the Reboot option.

! Click the Send button to send the selected KIT file to the specified device. You can watch

the progress of the transfer in the Send to NetLinx Device dialog.

! When the transfer is finished, and the reboot is complete, press the Close button.

Allow 20-30 seconds for NetLinx Masters to reboot. When the Master has rebooted,

the Status LED on the front panel blinks once a second to indicate that it is

functioning properly. Once it has rebooted, click OK.

Contents

Main AMX Limited Warranty and Disclaimer Table of Contents Page Product Information Specifications NXM-ME260 Specifications Ethernet ports used by the ME260 NXM-ME260 Specifications (Cont.) Ethernet Ports Used by the ME260 Rear panel LEDs: ICSNet/ICSHub Modes and LED Blink Patterns A static IP must be used for both the Master and computer if there is no DHCP server. Rear panel LEDs: Ethernet Page Installation and Wiring Setting the Program Port DIP Switch Program Port Connections/Wiring ICSNet RJ-45 Connections/Wiring ICSHub RJ-45 Connections/Wiring Ethernet 10/100 Base-T RJ-45 Connections/Wiring SPE Port Connection/Wiring SPE Connector Pinouts and Signals Do not use a standard phone extension cable; it will not work with the AXB-SPE. Mounting the Modules Into an Equipment Rack Mounting the NXC-ME260 in an NXF CardFrame or NXI Replacing the Lithium Batteries Programming Program Port Commands SET DATE TIME SET TIME DEVICE STATUS <D:P:S> DNS LIST <D:P:S> DISK FREE GET IP <D:P:S> MEM MSG ON or MSG OFF OFF <D:P:S, channel> PASS <D:P:S> PING <IP ADDRESS> PROGRAM INFO PULSE <D:P:S, channel> REBOOT <D:P:S> ROUTE MODE DIRECT|NORMAL SEND_COMMAND <D:P:S> SEND_STRING <D:P:S> SET DNS <D:P:S> SET IP <D:P:S> SET URL <D:P:S> SHOW COMBINE SHOW DEVICE <D:P:S> SHOW LOG SHOW NOTIFY SHOW REMOTE SHOW ROUTE SHOW SYSTEM ESC Pass Codes TCP LIST URL LIST <D:P:S> ESC Pass Codes + + ESC ESC Notes on Specific Telnet/Terminal Clients Firmware Transfers Sending Firmware to a NetLinx Device (KIT file) Page NetLinx Security NetLinx Security Features Security Terms Used in This Document Page Initial Setup (via Telnet or Terminal Connection) Page The Master must be rebooted after changing the HTTP setting. Security Options Menu Page Page Page Page Page Page Page Main Security Menu The Main Security menu is described below: Main Security Menu Default Security Configuration Page Logging Into a Session Logout