USING DOS DEMONSTRATION SOFTWARE:
On the enclosed disk is the demonstration software for the Z1, Z1e,
Driver Program
Z1.EXE
DOS Demonstration Program
ADG.EXE
To run the Demonstration Software:
1.Load the included disk files into their own directory on your hard disk using the DOS copy command (all files must be in the same directory)
2.Install your mouse driver.
3.Install the
4.Run the demo ADG.EXE A=(I/O Address) I=(Interrupt) ex. C>ADG A=380 I=10 (This is the default setting.)
5.At this point there should be a short pause as the board initializes, then the demo environ- ment should appear(Fig. 6)
Note: The left button of your mouse is to exe- cute a command, the right is to escape. You may also use the highlighted letter of the command to access it directly from the keyboard.
15