3. SETUP MENU continued …

3.6SOURCE SETUP

This is where you set up each Source and Path according to how you want them to be used.

6. SOURCE SETUP

a. CD b. 2-Ch c. 6-Ch d. TAPE e. FM/AM f. DVD1 g. DVD2 h. DVD3 i. DVD4 j. TV1 k. TV2 l. TV3 m. TV4 n. SAT1 o. SAT2 p. VCR q. AUX

r. ZONE2 COPY: Manual

s. ZONE3 COPY: Manual

t. REC COPY: Manual

Copy MAIN to ZONE or REC:

If you want MAIN to always be copied to another Path (see section 4.3), change ‘Manual’ to ‘Always’. This is recommended if you want a Source that only has digital audio output to be used in ZONE2, ZONE3, or REC, or if you want MAIN and another Path to always play the same Source. ‘Always’ setting is not recommended if you want Source selection to be independent – in this case, see the highlighted part of section 2.2.

Source Setup:

Besides setup of each source, DVD, TV, and SAT have expanded memory allowing you to set multiple configurations, which are useful for two reasons:

•Use multiple layers for same source, with different video adjustments on each layer, such as aspect ratio control (see section 4.11).

•Use multiple layers with different sources when you have more than nine source components.

To enable DVD2, DVD3, DVD4, TV2, TV3, TV4, or SAT2, at the top of its submenu change SAME AS to either ‘Custom’ to create its own Source Setup profile, or to any of the other Sources to use the same Source Setup profile but with different video processing adjustments.

To copy settings from one Source to another layer while having the ability to make changes to the new layer, select another Source for SAME AS then press SELECT. When asked ‘Are you sure?’ that you want to copy settings use the ￿￿buttons to change ‘No’ to ‘Yes’ and then press SELECT. The new layer becomes ‘Custom’ using the copied settings and changes can then be made.

Once set up, select a layer either by pressing the Source button one, two, three, or four times, or through the direct-access macros in Appendix A.

30