3. SETUP MENU continued …

Muting (applies to MAIN only):

This eliminates ‘popping’ sounds that may occur with some digital source components during a bitstream change. If popping is heard when changing chapter on a DVD or channel on a digital satellite receiver or cable box, use Max setting. However, if the beginning of a track is cut off when playing a CD, use Min setting.

EQ (applies to MAIN only):

For Sources set to Digital or Anlg-DSP, you can preset low and high frequency levels. This is useful for source components that have frequency irregularities. After highlighting the EQ line, press SELECT and use the

￿￿buttons to select LF (low frequency) or HF (high frequency), then use the ￿￿ buttons to adjust. In the FM/AM Setup/Presets menu, FM and AM can be adjusted separately. The EQ settings in this menu and the ‘on-the-fly’ BASS / TREBLE adjustments do not affect each other (see section 4.7).

Bass Manager (MAIN only):

Choose between Movie or Music configuration as set in menu 3, or Auto-LFE. When Auto-LFE is selected, the Movie configuration is used if there is LFE in the source material, and changes to the Music configuration at all other times. Auto-LFE is recommended when using two bass management configurations and the same player for DVDs and CDs.

Lip-Sync(MAIN only):

Video can fall out of synchronization with audio for a variety of reasons. The AVM 50’s video processing causes video to be delayed by 24 milliseconds, which is less than the duration of one frame, thus considered synchronized. If for whatever reason audio is heard before the corresponding image is seen, you can set up to 85 milliseconds of audio delay. You can also set delay while watching video – see section 4.9.

Example: Set DVD1 Lip-Sync delay to 24 milliseconds.

•Enter the Setup Menu. Go to ‘6. SOURCE SETUP’ and press SELECT.

•Press the ￿ button until you reach ‘f. DVD1’ and press SELECT.

•Press the ￿ button until you reach ‘m. LIP-SYNC’ and press SELECT.

•Use the ￿￿buttons to move from digit to digit and the ￿￿ buttons to adjust to ‘24 ms’.

•Press BACK to leave the submenu and return to the main menu.

HDMI Repeater:

If an HDMI input is assigned correctly yet it doesn’t work, try changing this setting to ‘No’.

33