3. SETUP continued …

SETTING UP THE PROCESSOR

Upon entering the setup menu your display will show the menu below. Only 8 menu items can be displayed at once – for clarity this manual shows each menu with all its items. On-screen display is recommended although the front panel shows similar information, one item at a time. If the default video output settings do not work with your display, use the front panel display to set video output. Setup menus are displayed through MAIN HDMI and Component (processed) outputs, and MAIN and ZONE2 S-Video outputs, whereas the 2-line status display and the video processing menu are displayed as follows:

MAIN on-screen display is available via HDMI1 output by default. On-screen display comes from HDMI2 and Component (processed) if “Preferred” is changed to “Component” in menu 1 submenus. S-Video on-screen display is available in both cases.

ZONE2 on-screen display is available via S-Video output.

 

 

1.

STATEMENT D2v SETUP

VIDEO OUTPUT

2.

SET TIME / TIMERS

3.

SPEAKER CONFIG

4.

LISTENER POSITION

5.

LEVEL CALIBRATION

6.

SOURCE SETUP

7.

MODE PRESETS

8.

ANALOG INPUT LEVELS

9.

ADC / AUDIO OUTPUT

10.

VOLUMES / PATH NAMES

11.

TRIGGER / IR / RS232

12.

DISPLAYS / TIMEOUT

13.

SAVE / LOAD SETTINGS

14.

LOCKOUT / PASSWORDS

SELECT Enters Submenu

To go to a submenu, highlight a menu item and press SELECT. Each on-screen menu also has a scrolling help line at the bottom as shown above.

3.1VIDEO OUTPUT

Highlighting VIDEO OUTPUT then pressing SELECT displays this menu:

1. VIDEO OUTPUT

a. VIDEO OUT CONFIG 1 b. VIDEO OUT CONFIG 2 c. VIDEO OUT CONFIG 3 d. VIDEO OUT CONFIG 4

16