Introduction
Initial Setup
Required network | You must configure the following network settings of the MasterSwitch |
settings | PDU before it can operate on a network: |
| • IP address of the unit |
| • Subnet Mask |
| • IP address of the default gateway |
| Note: If a default gateway is not present, enter an IP address |
| of a computer that is on the same subnet and that is |
| always active. |
Configuring TCP/IP | To configure TCP/IP settings, see TCP/IP on page 15 and see the |
settings | MasterSwitch Installation and Quick Start Manual, included in printed |
| form with the MasterSwitch PDU and in Portable Document Format |
| (Install.pdf) on this |
Customizing your | After you configure MasterSwitch network settings, no further |
configuration | configuration is required. The remaining MasterSwitch properties are |
| |
| to customize these properties for your application. For more information, |
| see Managing the MasterSwitch PDU on page 5. |
| The management card within the MasterSwitch PDU supports an auto- |
| configuration utility that you can use to create a configuration file, which |
| you can then download to other MasterSwitch PDUs, either to individual |
| units one at a time or to multiple units at the same time. For more |
| information, see the Management Card Addendum (addendum.pdf |
| on the MasterSwitch |
MasterSwitch Power Distribution Unit User’s Guide | 4 |