To set the Delay time for the sequenced outlets:
Push the SEQ/AVR push button briefly; all LEDs are extin- guished, indicating the H10 is in delay programming mode. The LED corresponding to the number of seconds of delay flashes (0s, 6s, 12s). To change the delay time, press the button until the LED corresponding to the desired number of seconds flashes. After releasing the push button, the unit returns to normal status and the normally illuminated LEDs are lit.
9LED Display and Unit Customization
The LED bars display voltage IN (line voltage) and LOAD. Additionally, the LED bars are used when programming fea- tures such as delay time and AVR range setting.
10On/Off switch
Controls power to all 12 outlets. APC recommends the H10 be left ‘on’ at all times.
11Dimmer Push Button
The LEDs, can be dimmed to any one of eight levels of bright- ness using the Dimmer push button. Simply press the push but- ton until the desired brightness level is achieved.
12Overload Status Indicator
This indicator will illuminate when the unit is overloaded; unplug equipment connected to the unit until the indicator is no longer lit.
- 6 -
