Set Up the H10
Using the front panel Dimmer and SEQ/AVR push buttons ( 8 and 11 , Figure 2) you can configure the following functions:
•Dimmer Function — The Dimmer function allows you to set the front panel LEDs to any of 6 brightness levels. Simply press the push button until the desired setting is achieved.
•AVR range Function — For information about how to set the AVR
range function, see 8 “SEQ/AVR Push Button” under the section on “Front Panel Controls and Indicators”
•Delay Time Function — Once the AVR range is set, repeatedly press the Setup push button to advance to the Delay Time Function (Figure 6) for the delayed outlets. Use the Select then Setup push button to select within a range from 0 to 12 seconds.
- 12 -
