APC URTA48XLBPJ Battery Pack and UPS Connection Procedure, Connectors, Type, Description

Battery Pack and UPS Connection Procedure

b. Install the UPS and battery pack battery covers  and bezels .



6. Go to “Terminal Mode Configuration” on page 9 to configure the UPS to recognize the battery pack(s).

Battery Pack and UPS Connection Procedure

The battery pack is equipped with the following connectors. Refer to the UPS user manual for UPS connector types and definitions.

Connectors	Type	Description
	TVSS screw	The UPS and battery pack features a Transient Voltage Surge-suppres-
		sion (TVSS) screw located on the rear panel, for connecting the ground
		cable on surge suppression devices such as telephone and network line
		protectors.
		NOTE: Prior to connecting the grounding cable, turn off the UPS and
		disconnect it from the utility power outlet.
	battery pack	Smart-UPS RT battery packs provide extended run-time during power
	connector	outages. A maximum of 10 battery packs can be used with the UPS.
		NOTE: See the APC Web site, www.apc.com for information on the
		battery pack, SURTA48XLBP or SURTA48XLBPJ.

Prior to connecting the grounding cable, ensure that the UPS is NOT connected to utility or battery power circuits. See the UPS user manual for additional

Caution instructions.

Smart-UPS RT SURTA48XLBP/SURTA48XLBPJ External Battery Pack User Manual 7