Apex Digital AP-16CO, AP-9060 Testing

Page 13 of 18

Testing

Testing from your LAN (Internal)

Open internet explorer and browse to the IP address that you assigned to your AP-

9060/AP-16CO.

You should be looking at the default screen for your AP-9060/AP-16CO.

Download and install the NetViewer software.

Run Netviewer.exe in the installation folder.

Click the icon of two PCs connected by a cable in the middle of the right-hand side of

your screen.

The network viewer connection screen opens.

Contents

Main Table of Contents Page Getting Started Introduction Disclaimer Quick Setup Guide (Power Users Only) Planning Gathering Information Page Page 7 of 18 Information Gathering Checklist Your routers internal IP address Your routers public IP address Your routers username and password Your networks DHCP range Your networks subnet Mask Pitfalls to Avoid IP Addresses in Your DHCP Range Dynamic IP Addresses Using Dynamic Public IP Addresses without Dynamic DNS Configuration Configuring your AP-9060/AP-16CO User Accounts Network Settings Page Configuring Your Router Checking For Conflicts Finalizing Your Setup Testing Testing from your LAN (Internal) Page Additional Resources Networking Firewalls