Apex Digital HT-180 manual Preparing The Remote Control, Open the cover, Insert batteries AAA size

Index of Parts and Controls Continued

PREPARING THE REMOTE CONTROL

To operate the HT-180, you must first place the batteries in the remote control.

1 2 3

Open the cover.	Insert batteries (AAA size).	Close the cover.
	Make sure to match the + and - on
	the batteries to the marks inside the
	battery compartment.

OPERATING WITH THE REMOTE CONTROL

Operating HT-180 with the remote control.

30˚ 30˚

The remote control must point at the remote sensor, in order for the HT-180 to function correctly.

Distance: Maximum of 7m from the front of the remote sensor.

Angle: Approximately 30˚ from each direction.

*Please do not place the remote sensor towards any light source such as direct sun- light or illumination. If you do so, the HT-180 will malfunction.

NOTICE

FOLLOW INSTRUCTIONS BELOW BECAUSE INCORRECT USE OF BATTERIES MIGHT CAUSE THEM TO LEAK OR CORRODE.

•Do not place the batteries in the wrong direction.

•It is dangerous to charge/heat/open or short-circuit the batteries.

•Do not leave dead batteries or mix old/new batteries in the remote control.

•When not using the remote control for a long duration of time, remove the batteries.

•If leakage from the battery occurs, wipe the battery liquid from the battery compartment, then replace the batteries.

H T - 1 8 0 A P E X D I G I T A L 11