Apollo 360 Map Display | Troubleshooting |
Appendix B
Troubleshooting
This appendix contains information to troubleshoot the Apollo 360 when improper operation is observed. The table below lists possible problems you could encounter while operating the unit. Examine the possible causes of the problem and take the action listed to correct the trouble. If you cannot correct the problem, contact your dealer. If your dealer is unavailable, contact the II Morrow factory at the address and phone number listed at the back of this appendix.
Problem | Possible Cause(s) | Action | |
|
|
| |
Unit does | Open in power | Check circuit breaker - | |
not power | supply circuit | reset if necessary | |
on |
|
| |
|
|
| |
| Faulty electrical | Contact your dealer to | |
| wiring or | perform electrical | |
| connection | system test | |
|
|
| |
No Host | Host device not | Ensure that host device | |
signal | turned on | is powered up | |
input |
|
| |
Faulty wiring or | Contact your dealer to | ||
| |||
| connection | check wiring ensure | |
|
| that unit is properly | |
|
| connected. | |
|
|
| |
Display too | Change in view | Adjust display backlight | |
dark or too | angle or ambient | (use backlight key) or | |
light - | light conditions | adjust display contrast as | |
characters | in cockpit | Section 5 describes in | |
hard to see |
| “Screen Controls” | |
|
| option | |
|
|
| |
|
|
|
P/N |