LOCATION CONSIDERATIONS
1.Install Unit Indoors: Do not expose to elements..
2.Drain Accessibility: A condensate pump may be required if a drain is not located in the installation area..
3.Power: Outlet within 8 ft.. of unit..
4.Filter Access: Allow for 20” of clearance on one side of unit for removal of filter (see Figure 2)..
5.Inlet: Allow for 12” of clearance to access control and control door/wiring access (see Figure 2)..
Table 1 – Location Notes
Requirement |
| Application Location |
| ||
Attic | Garage | Basement | Crawl Space | ||
| |||||
|
|
|
|
| |
All ductwork must be |
|
|
|
| |
insulated and sealed.. |
|
|
|
| |
|
|
|
|
| |
Drain pan with overflow |
|
|
|
| |
protection placed under unit.. |
|
|
|
| |
|
|
|
|
|
Figure 2 – Dimensions and Location Considerations
(527) | (64) |
|
| (241) | |
| (98) | |
|
| |
Air Outlet |
| |
| (165) | |
8 in. |
| |
|
| |
Round |
|
|
Collar |
|
|
Damper
Fully Open
OFF/ON Switch
Drain | OFF |
ON | |
(32) | (264) |
24.00
(610)
Air Flow
Power Cord
(64) | (527) |
| 11 |
| (279) |
9
(229)
(498)
Air Inlet
Wiring8 in.
Access Round
Collar
Filter Access | 3 |
|
(Front and Back) | Adjustable Legs | |
| (76) |
|
OUTLET AIR END
Two Support Struts
for Suspending
(Bottom of Unit)
IF SUSPENDING THE UNIT, USE
TWO STRUTS TO SUPPORT THE
BASE ON THE OUTSIDE EDGES
OF THE FEET LOCATIONS.
20 in. (508mm) Minimum Clearance
for Filter and Front Panel
Removal (either side)
FRONT VIEW
SERVICE
CLEARANCE
TOP VIEW
OF UNIT
SERVICE
CLEARANCE
Max.
INLET AIR END
THERE MUST BE AT LEAST
20 IN. (508mm) OF CLEARANCE
ON EITHER SIDE FOR
FILTER REMOVAL
THERE MUST BE AT LEAST
12 IN. (305mm) OF CLEARANCE
ON BOTH ENDS FOR
CONTROL SETTINGS
3 in. (76mm) Minimum Clearance for Filter and Front Panel
Removal (either side)
6 in. (152mm) Minimum Clearance for Filter and Front Panel
Removal (either side)
SUSPENDING AND SERVICE CLEARANCE
4