on the metal. Rubbing cleanser as gently as possible in the direction of the polished lines will not mar the finish of the stainless steel. NEVER RUB WITH A CIRCULAR MOTION. Soil and burnt deposits which do not respond to the above procedure can usually be removed by rubbing the surface with
7.Pull spring clip to remove stirrer from drive shaft. Align hole in stirrer and drive shaft to reinstall clip.
8.Lift off kettle cover. A mild abrasive cleaner and PLASTIC scouring pad may be used to remove oil
9.Remove all unpopped corn from drawer and wipe out entire cabinet. Clean cabinet and doors with mild soap and water. Dry with soft towel.
DO NOT USE ordinary steel wool as any particles left on the surface will rust.
NEVER USE a wire brush, steel or abrasive scouring pads (except stainless), scraper, file or other steel tools. Surfaces which are marred collect dirt more rapidly and become more difficult to clean. Marring also increases the possibility of corrosive attack.
NEVER USE any corrosive cleaner. Use only cleaners approved for stainless steel.
! | WARNING: Unit is not waterproof. NEVER clean any electrical unit by immersing it in water. Turn off | ! | |
unit before cleaning surface. | |||
|
|
|
|
| ! | WARNING: SHOCK HAZARD - To avoid electrical shock, always | ! |
| equipment before performing cleaning or maintenance. | ||
SERVICE / REPAIR
NOTE: THIS APPLIANCE MUST ONLY BE SERVICED BY AN AUTHORIZED AGENT.
NOTE: Parts protected by the manufacturer or his agent are not to be adjusted by the installer, unless the installer is an authorized service agent.
Maintenance and repair should be handled by a factory authorized agent. Before doing any maintenance or repair, contact APW Wyott Foodservice Equipment Company at (800) 7520863 or (800)
If you have any questions or problems, contact your nearest APW Wyott Service Representative.
TROUBLE SHOOTING GUIDE
If the unit fails to operate, check the following:
1.Is the unit connected to a live power source?
2.Check circuit breaker?
3.Is power switch on?
4.Check the data plate. Are you operating the unit on proper voltage?
5.Is the supply cord damaged? If it is, it should only be replaced by an identical supply cord.
If the above checks out and you still have problems, call an APW WYOTT authorized service agency.
NOTICE: Service work should be performed only by a qualified technician who is experienced in and knowledgeable with the operation of commercial gas, electric, steam cooking equipment. Contact the Authorized Service Agency for reliable service, dependable advise or other assistance and for genuine factory parts.
6
