Aqua-Vu none manual Your DT Package, Easy Setup

IN YOUR DT PACKAGE. . .

The package contains Aqua-Vu DT (Depth-Tech) components. You'll be viewing-ready in a few minutes!

•Monitor (weatherproof; attaches to the Carrying Shuttle; tilts up and down for convenient viewing, holds ON-OFF-ON/LIGHT switch)

•Carrying Shuttle with handle (allows cable and camera storage; tiltable monitor attaches to it; holds Mode and Function buttons.)

•Soft custom Carrying Case

•Camera with Multi-Color light option and 60- or 120-foot cable

•Detachable Sunshield (stores conveniently on carrying shuttle when not in use)

•Battery (12-volt, 7-amp)

•Battery Charger

•Ballast Weights (for open-water viewing)

•Front-viewing Fin (keeps camera forward-looking as it's pulled through the water)

If any of the above items are missing, contact Nature Vision immediately.

EASY SETUP

Your Aqua-Vu DT requires no complex assembly. Follow these simple steps:

1.Connect the monitor to the Carrying Shuttle (a one-time procedure) using the two black plastic headed thumbscrews provided. (You will tighten and loosen these thumbscrews every time you use the Aqua-Vu DT - for positioning/tilting the monitor for the most convenient viewing, as well as for carrying and stowing the unit.)

2.Plug the camera cable into the "CAMERA IN" port (a one-time procedure).

3.Place the battery into the battery well in the Carrying Shuttle, with battery terminals towards the lower end of the unit (opposite from handle). Position the battery lock tabs to secure the battery in place. Connect the red wire clip to the red terminal on the battery (red to red). Connect the black wire clip to the black terminal on the battery (black to black).

You may also power the Aqua-Vu DT by means of an Auxiliary Power Cord accessory that plugs into a cigarette lighter in vehicle or boat. The DT can operate off any 12-volt power source. (The Auxiliary Power Cord accessory is available through retailers, or online at www.aquavu.com.)

Nature Vision, Inc. © Copyright 2000 Pg 2