Back Panel
1.Inputs: The DXE has two RCA inputs that need to get their audio signals from the source units (CD Player and Video system). If your source unit has multiple outputs (like a front, rear, and/or subwoofer) you should only connect the front or rear outputs to your DXE.
2.Input Levels: These switches allow you to maximize the signal level from your source unit that goes into your DXE to achieve maximum signal to noise. Keep in mind, that despite what the literature says, most aftermarket source units produce a relatively low voltage signal when it comes to playing music at normal levels.
3.Balanced Outputs: This balanced line connector should be connected to the DXE crossover module, be careful to plug it into the right spot.
4.Power Connection: This connector looks like a Telephone cable. Well it is, but this removes the power supply from the EQ and moves it into the crossover were there is room to shield it properly. As a result you get much lower noise and no chance of ground loop.
L | R | L | R | OUTPUT | POWER |
|
|
| GAIN |
| |
|
|
| 0db 6db 12db | 0db 6db 12db |
|
| INPUT A |
| INPUT A | INPUT B |
|
|
| INPUT B |
|
| |
5