ADJUSTING STEERING LEVERS | Eccentric Spacer | ||||
(Figure 20) |
|
| |||
|
| Rotate this end away from the operator | |||
|
|
|
| ||
Adjustment 3 | Adjustment 1 |
| position to move the steering levers in. | ||
|
| ||||
1 |
| 3 |
|
| |
|
|
|
| Rotate this end away from the operator | |
|
|
|
| position to move the steering levers out. | |
|
|
|
| Figure 21 | |
2 |
|
|
| 3. Adjust Steering Lever Forward or | |
|
|
|
| Backward | |
|
|
|
| 1. Loosen, do not remove, the bolts | |
|
|
|
| securing the handlebar to the upper | |
|
|
|
| control arm. | |
|
|
|
| 2. Slide steering lever forward or backward | |
| 6 | 5 | 4 | to desired position and tighten bolts. | |
| NOTE: Tighten upper bolt first. | ||||
|
|
|
| ||
|
| Adjustment 2 | Forward and Reverse Speed | ||
1. | Handlebar |
| Adjustment | ||
2. | Upper Control Arm |
| (Figure 22) | ||
3. | Adjustment Holes |
| |||
| IMPORTANT: The unit should track within | ||||
4. | Eccentric Spacer |
| |||
5. | Mounting Hardware |
| 2 feet (0.61 m) of a straight line for 30 feet | ||
6. | Lower Control Arm |
| (9.14 m). | ||
|
| Figure 20 |
| The travel of the steering levers may need | |
|
|
| adjustment if: | ||
IMPORTANT: Adjust each steering lever | |||||
• The unit turns to the right or left when | |||||
equally. |
|
|
| both steering levers are pushed as far | |
NOTE: When adjusting steering levers for the | |||||
forward as possible. | |||||
first time it is recommended that you make | |||||
• The unit turns to the right or left when | |||||
adjustments in the following order. |
| ||||
1. Adjust Steering Lever Height | both steering levers are pulled back as | ||||
1. Remove mounting hardware that | far rearward as possible. | ||||
NOTE: The side the unit turns toward | |||||
attaches the handlebars to the upper | |||||
control arm. Move handlebar up or down | indicates that the wheel on that side is turning | ||||
until the handlebar mounting holes are | slower than the other wheel. Either the wheel | ||||
aligned with the prefered adjustment | that is turning faster needs to slow down or | ||||
holes. |
|
| the wheel that is turning slower needs to be | ||
2. Install mounting hardware and tighten. | sped up to allow the unit to travel in a straight | ||||
2. Adjust Steering Lever Width | line. | ||||
1. Determine which way the unit turns. | |||||
1. Loosen hardware at the base of the | NOTE: The forward travel adjustment bolt | ||||
lower control arm item 5. |
| adjusts the rear travel of the steering lever. | |||
2. Rotate eccentric spacer to move the | The rear travel adjustment bolt adjusts the | ||||
levers away from or closer to the | forward travel of the steering lever. | ||||
operators position (figure 21). |
| 2. Adjust speed by loosening jam nut and: | |||
|
|
|
| • Turning adjustment bolt clockwise to | |
|
|
|
| decrease steering lever travel. | |
|
|
| GB - 23 | ||
