Timer (TMR1): measures the time spent on individual jobs.
Press and hold the toggle button to reset the timer to zero. TMR1 will then start measuring engine run time until it is reset to zero again.
Service Alert (Chg Oil, Chg H Oil & Filter, SVC Airfilter): reminds operators of the
maintenance interval for changing the engine oil, changing the hydraulic oil and filter and servicing the air filter.
The alert starts counting down two hours before the maintenance is due. The meter flashes the word, "Now," when it reaches the maintenance time.
Press and hold the toggle button to reset the maintenance clock to zero after performing the service.
NOTE: The hour meter is preprogrammed for the initial oil change at 25 hours and for 100 hours thereafter. The hour meter is programmed for the initial hydraulic oil and filter change at 75hours and for 400 hours thereafter.
Display
Toggle Button
Steering Levers
•Reverse (1) – Pull both steering levers backward.
•Forward (2) – Push both steering levers forward.
•Left (3) – Pull left steering lever back or push right steering lever forward or a combination of both.
•Right (4) – Pull right steering lever back or push left steering lever forward or a combination of both.
1 | 2 |
3 | 4 |
NOTE: To stop, return both steering levers to neutral.
NOTE: The steering levers must be in the neutral position to start the engine. NOTE: The parking brake must be disengaged prior to moving the steering levers from the neutral position.
Mower Lift Pedal
(Figure 6)
Raises and lowers the deck.
1 | 3 | 2 |
| ||
|
|
1.Adjustment Pin
2.Mower Lift Pedal
3.Adjustment Hole
Figure 6
NOTE: The adjustment pin is used to set the height of the mower deck. See SPECIFICATIONS on page 31 for cutting height dimensions.
7 | 02988000 |
Press mower lift pedal and install adjustment pin in the desired adjustment hole.
| NOTE: Adjusting the seat |
| further forward will help |
| increase the leverage in |
08088400A | lifting the mower deck (see |
page 15). | |
| Adjusting Seat on |
GB - 14
