Check Function of Dual Handle Interlock
Without the engine running, press down (engage) both clutch levers. Release attachment clutch lever. Attachment clutch should remain engaged until traction clutch lever is released, then both clutches must disengage. If they do not, contact your Dealer for repairs.
Check Tire Pressure
(921013, 017, 018, 019, 020, 022)
Check tire pressure and adjust to the pressure listed on tire sidewall.
CAUTION: Avoid injury! Explosive separation of tire and rim parts is possible when they are serviced incorrectly:
•Do not attempt to mount a tire without the proper equipment and experience to perform the job.
•Do not inflate the tires above the recommended pressure.
•Do not weld or heat a wheel and tire assembly. Heat can cause an increase in air pressure resulting in an explosion. Welding can structurally weaken or deform the wheel.
•Do not stand in front or over the tire assembly when inflating. Use a
Check Track Tension (921023)
Check tracking of unit with the differential locked, and tension of tracks (see Track Tension Adjustment on page 35).
Check Auger Gearcase Oil
Check oil level in auger gearcase (see Check Auger Gearcase on page 25).
Check Engine Crankcase Oil
IMPORTANT: The engine is shipped with
Fill Engine Fuel Tank
See Filling Fuel Tank on page 20.
For Model 921020: Remove the plug from the fuel tank and install the fuel cap located in the literature pack.
Check Function of all Controls
Ensure unit runs and performs properly. Refer to OPERATION on page 16.
Run-in Attachment Belt
1.Start unit in a
2.Engage attachment clutch lever and run attachment for about 15 minutes.
3.Stop unit, wait for all moving parts to stop, and remove spark plug wire.
4.Adjust belt finger, if necessary. See Check Belt Finger Clearance on page 31.
5.Adjust clutch idler according to Attachment Clutch/Brake Adjustment on page 29.
GB - 12