5.Check function of remote wheel lock. If wheel lock does not function properly, remove bottom cover to check cable slack.

6.Repeat steps 2 – 4 while watching cable to remove slack.

7.Check function of remote wheel lock. If wheel lock does not function properly, take the unit to Dealer for repairs.

3

1

No Slack

2

OS7170

 

1.Top Jam Nut

2.Bottom Jam Nut

3.Cable Adjuster

Figure 28

REMOTE DEFLECTOR CONTROL (921013, 017, 018, 020, 022, 023)

(Figure 29)

Deflector must stay in selected position while throwing snow.

If deflector does not stay in set position:

1.Tighten nut beneath control panel to increase pressure on deflector control.

If deflector does not follow full range of travel:

1.Push deflector remote all the way forward.

2.Loosen adjusting nuts on cable support bracket underneath the dash panel (Figure 29).

3.To adjust the deflector lower:

Slide cable down. Tighten bottom nut.

4.To adjust deflector higher: Slide cable up. Tighten top nut.

5.Check travel and repeat adjustment as necessary.

OS7175

12

1.Adjusting Nuts

2.Cable Support Bracket

Figure 29

DISCHARGE CHUTE CONTROL (921017, 018)

(Figure 30)

If chute does not stay in position while throwing snow or if chute does not rotate freely, adjust the cable under the gear cover so the chute lock fingers engage or disengage the locking gear.

If chute does not stay in position:

Loosen the cable by loosening the rear adjustment nut, and then tightening the forward adjustment nut against the bracket until the lock arm engages the gear teeth (Figure 30).

1.Forward Adjustment Nut

2.Rearward Adjustment Nut

Figure 30

OS7181

GB - 27