Snow Clean-Out Tool

(Figure 17)

WARNING: Hand contact with the rotating impeller is the most common cause of injury associated with snow throwers. Never use your hand to clean out the discharge chute.

1

1. Snow

Clean-Out

Tool

Figure 17

OS7102

 

To clear the discharge chute:

1.Shut off the engine.

2.Wait 10 seconds and make sure impeller blades have stopped rotating.

3.Remove the snow clean-out tool (1) from the auger housing and use it to remove the clog from the discharge chute.

4.Replace the snow clean-out tool on the auger housing.

Remote Deflector Control (921013, 017, 018, 020, 022, 023)

Place deflector into position before operation. DO NOT throw snow any higher than necessary.

Place deflector remote in a forward notch to throw snow lower. Place deflector remote in a rearward notch to throw snow higher.

Manual Discharge Deflector (921019)

(Figure 18)

ALWAYS position discharge chute deflector at a safe angle before starting engine. DO NOT throw snow any higher than necessary.

1. Push deflector handle forward or down to throw snow lower.

2. Pull deflector handle up or to the rear to throw snow higher.

1

1. Deflector

Handle

Figure 18

OS7103

Discharge Chute

Discharge chute rotates 200°.

ALWAYS position discharge chute in safe direction and angle, away from operator and bystanders, before starting engine.

Discharge Chute Control (921017, 018)

(Figure 19)

IMPORTANT: If chute does not stay in set position, adjust as directed in Discharge Chute Control on page 27, or repair before operation.

Rotate the Chute with Discharge Chute Control (Figure 19).

OS7105

Figure 19

GB - 18