If chute does not rotate freely:

Tighten the cable by loosening the forward adjustment nut, and then tightening the rear adjustment nut against the bracket until all cable slack is removed (Figure 30).

MANUAL DISCHARGE

CHUTE DEFLECTOR

(921019)

(Figure 31)

Deflector must stay in selected position while blowing snow.

To adjust, loosen then retighten hardware to desired deflection drag force (Figure 31).

Adjusting

Discharge Chute

Deflector

Hardware

 

Discharge

Chute

Figure 31

OS7176

DISCHARGE CHUTE (921013, 019, 020, 022, 023)

(Figure 32)

If discharge chute does not stay in position while operating, tighten nut on carriage bolt at pivot point to increase tension on spring.

1

2

1

OS7177

2

1.Spring

2.Nut

Figure 32

SPEED SELECTOR

ADJUSTMENT

(Figure 33) To adjust:

1.Disconnect adjustment pivot pin from speed selector lever by removing hairpin.

2.Place the speed selector on the dash in the fastest forward speed position.

3.Turn the speed selector lever straight down towards the ground as far as it will go.

4.Thread the adjustment pivot pin along the shift rod until it aligns with the mating hole on the speed selector lever. Insert the pivot pin into hole.

5.Secure adjustment pivot pin with hairpin.

6.Make sure the speed selector shifts into each speed position.

7.Check forward and reverse speeds:

a.Start unit.

b.Shift speed selector into the first forward speed.

GB - 28