Manuals / Ariens / Lawn and Garden / Snow Blower

Ariens 921024 quick start Step Four Install Remote Deflector Control Cable

Models: 921024

1 29

Download 29 pages 8.38 Kb

Page 11

Step Four: Install Remote

Step Four: Install Remote

Deflector Control Cable

1.Connect the barrel cable end to the chute deflector cable anchor before clipping the cable to the discharge chute cable bracket.

2.Route deflector remote cable along the left side of the chute pedestal.

3.Insert the barrel on the cable end into the bracket on left side of chute deflector.

4.Hold seal out of the way while routing the cable through the bracket on the left side of the discharge chute, and then push the cable fitting into the bracket.

5.Push the seal securely over the end on the cable fitting to prevent water from entering the cable.

6.Check deflector travel. Adjust nut on cable end under handlebar to obtain full travel, if necessary see Remote Deflector Control in Owners Manual.

Image 11

Ariens 921024 quick start Step Four Install Remote Deflector Control Cable

Contents

Deluxe 24 921024 s/n 101 & up Quick Start GuideNot attached Step One Assemble HandlebarsNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Lower HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Upper Handlebar AssemblyNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Attach Control Cables1. Hook Spring end of attachment control cable to the clutch arm NOTE Make sure the cable remains in the groove of the pulleyNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Unfold Upper HandlebarNOTE This slide applies to UNATTACHED handlebars ONLY Step One Assemble Handlebars Connect Headlight Wire HarnessNOTE This slide applies to ATTACHED handlebars ONLY Step One Assemble Handlebar1. Grease underside of discharge chute ring if not already greased Step Two Install Discharge Chute2. Remove mounting hardware from auger housing Step Three Install Discharge Chute Crank Step Four Install Remote Deflector Control Cable Step Five Check Function of Dual Handle Interlock Step Six Check Tire Pressure Manual Step Seven Adjust Skid ShoesSkid Shoes in Owners Check oil level in auger gearcase Step Eight Check Auger Gearcase OilIMPORTANT The engine Step Nine Check Engine Crankcase Oil Ariens AXFILLING FUEL TANK in Step Ten Fill Engine Fuel Tank Ariens AXFill fuel tank. DO NOT OVERFILL! See Engine Ariens AX Step Eleven Starting theTurn throttle all the way up. Turn choke ON Starting Engine / Step A ChokePush rocker switch to RUN position Starting Engine / Step B Rocker SwitchTurn fuel petcock to ON position Starting Engine / Step C Fuel Shut Off ValveStarting Engine / Step D Key Starting Engine / Step E Prime Starting Engine / Step F Manual Start Starting Engine / Step F Electric Start Press and hold starter button Starting Engine / Step G Electric StartCHOKE OFF position Starting Engine / Step H Warm upUnder normal conditions 1. Turn throttle down Step Twelve Stopping the Engine Ariens AX2. Push rocker switch to STOP position 3. Pull safety key OUT E-mail info@ariens.com Additional ResourcesRefer to Owners Manual and Engine Manual Contact Ariens Company