ASSEMBLY

WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding.

WARNING: Dropping or tipping over boxed unit could result in personal injury or damage to unit.

5.Install and tighten all wing knobs and wing nuts on the handlebar assembly and shift rod.

NOTE: The handlebar has two height positions. Adjust the handlebar height to provide better operator comfort. See Handlebar Height on page 22

NOTE: Model 926023 ships with the handlebar assembly detached from the unit. Slide the handlebar assembly into position and fasten with wing nuts.

PACKAGE CONTENTS

4 1

.

.

5

4

1

3

2

 

OS7020

1. Sno-Thro Unit

4. Literature Pack with

2. Discharge Chute

Extra Shear Bolts

3. Chute Rod

 

Figure 3

ASSEMBLY

Tools Required:

•Pliers

•Open-End Wrenches: 3/8, 7/16, 1/2, 9/16 in. and/or Adjustable Wrench

•Tire Gauge

Unfold Handlebar (Figure 4 )

1.Remove the lower and loosen the upper wing knobs on the handlebar assembly.

2.Loosen the wing nuts on the shift rod.

3.Put the speed selector lever in the first forward position

4.Rotate the handlebars into operating position.

1

2, 3

1. Wing Knobs

4. Shift Rod

2. Wing Nut

5. Speed Selector Lever

3. Bolt

 

Figure 4

OS7030

Install Discharge Chute and Discharge Chute Crank921002, 003, 004921301

(Figure 5)

1.Grease underside of discharge chute ring (if not already greased).

2.Remove mounting hardware from auger housing.

3.Install discharge chute over opening in the auger housing. Finger tighten the mounting hardware removed in step 2.

NOTE: Leave discharge chute pedestal loose to help install the chute rod and connect it to the control assembly.

GB - 7