Ariens Pro-24 HWSP Wheel Drive Actuation Link, Operator Presence Control (OPC), Installation, Cable Installation

Wheel Drive Actuation Link			Operator Presence Control (OPC)
Installation			Cable Installation
See Figure 6.			See Figure 7.
10. Apply pressure against the wheel drive			NOTE: The OPC lever (Figure 15, Item 1) is
(self-propel) mechanism to hold it down			mounted on the left-hand end of the
against rear wheels. This will provide the			handlebar. The OPC cable is routed down the
required clearance to install the wheel			right side of the handlebar to the front of the
drive actuation link on the bellcrank stud.			engine.
11. Install a flat washer, the actuation link				1. Connect OPC cable end to front of
and a second flat washer on bellcrank				engine. The Z-bend end of the cable is
stud.				installed into the engine flywheel brake
12. Install hairpin through bellcrank stud to				actuation arm through the bottom side.
secure actuation link.				2. Slide cable wire through slot in cable
				mounting bracket.
Bellcrank
				3. Press cable clip into bracket hole from
		Wheel		backside until tabs lock clip in place.
		Drive
		Actuation
		Link
		Flat
		Washer						Oil
		Bellcrank						Fill
		Stud			OPC		Engine
	Hairpin			Cable End			Flywheel
			Cable Clip				Brake	Cable
							Actuation
								Mounting
						Slot	Arm	Bracket

(Front of Engine)

Figure 6

Figure 7

GB - 10