Frame

 

 

 

Height

 

 

 

 

 

 

 

of Cut

 

 

 

 

 

 

 

Holes

 

 

Wheel

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Axle

 

 

 

 

 

 

 

 

Bolt

 

Inside View

Figure 18

Front Wheel Height Adjustment

See Figure 19

IMPORTANT: Front wheel height must be set the same as rear wheel height for proper height of cut.

1.Stop engine, wait for all moving parts to stop and hot parts to cool.

2.Place unit on a flat, level surface.

3.Disconnect spark plug wire from spark plug.

4.Raise front of mower to lift front wheels off the ground. Support front of mower deck with jackstands, blocking or other similar, stable support.

The height of the standard, fixed front wheels is changed by raising or lowering wheels in the four available mounting holes in each wheel support. Place wheels in upper holes for a lower cut and lower holes for higher cut.

NOTE: Height-of-cut holes are spaced approximately 0.665" (17mm) apart. The mower is set-up at the factory in the second from the lowest position, for a 2.7" (69mm) cut height.

5.Hold axle bolt stationary with wrench while removing inner nut.

6.Move each front wheel and axle bolt to desired height-of-cut hole.

7.Hold axle bolt stationary with wrench while tightening inner nut against support.

8.Connect spark plug wire to spark plug.

 

 

 

 

 

Wheel

 

Inner

 

 

Nut

 

 

 

 

 

 

 

 

 

 

 

Axle

 

 

 

 

Bolt

 

 

 

 

 

 

 

Outer

 

 

 

 

 

 

 

 

 

 

 

 

Nut

 

 

 

 

 

 

 

 

 

 

Height

Support

 

of Cut

 

Figure 19

Holes

GB - 18