Support Clamp Cable Tie Handlebar
Handlebar
Support
Cable
Tie
Figure 9
Recoil Rope Set-Up
Loosen lock nut on inner side of handlebar bracket until rope guide mounting cap screw is loose enough to allow lower half of guide to be rotated away from upper half, opening rope guide. See Figure 10.
1.Hold OPC lever fully depressed while slowly pulling recoil rope out past handlebar. Release OPC lever while holding recoil rope extended. See Figure 11.
Rope
Guide
Closed
Recoil Rope | Mounting Cap Screw |
Rope
Guide
Opened
Figure 10
2.Position recoil rope in upper half of guide and then rotate lower half back to close guide, capturing rope. See Figure 10.
OPC Lever
Handlebar
Bracket
Recoil
Rope
See
Figure 11
NOTE: Ensure mounting cap screw is properly seated in lower half of rope guide.
3.Tighten lock nut on inner side of handlebar bracket to secure rope guide halves together.
GB - 12