ASSEMBLY
ASSEMBLY |
|
|
| ||
Handlebar |
|
| |||
|
|
|
| ||
CAUTION: AVOID INJURY. Read |
|
|
| ||
|
|
|
| ||
and understand the entire Safety |
|
|
|
| |
section before proceeding. |
|
|
|
| |
|
|
|
|
| |
NOTE: The mounting hardware described in |
|
|
| ||
the following assembly procedures is factory- |
|
|
| ||
mounted on the mower in the proper | Frame |
|
| ||
Handlebar | |||||
locations. | |||||
| |||||
Handlebar Installation |
| Support | |||
|
|
| |||
1.Remove mower, handlebar and discharge chute from carton. See Figure 3.
Stud
Figure 3
2.Pull both handlebar supports back to vertical position.
3.Remove handlebar mounting hardware from mower frame.
4. Place the lower hole of one end of the handlebar on frame stud. Spread lower ends of handlebar until the opposite end can be installed on frame stud. See Figure 4.
5. Install flanged lock nuts on studs. Do not tighten fully.
6.Install round head square neck bolts through upper holes in frame and handlebar and secure loosely with
Figure 4
Support Handlebar
Clamp Support
| flanged lock nuts. See Figure 5. | Handlebar | |
7. | Slide each support clamp on handlebar | ||
| to align with vertical support and connect |
|
|
| with hex cap screw and flanged lock nut. |
|
|
|
|
| |
8. | Tighten all mounting hardware installed |
|
|
| in steps 5 through 7. |
|
|
9. | Tighten hardware securing lower end of | Locknut on Stud | Upper Mounting |
| each handlebar support to frame. | ||
| Frame | Figure 5 | Hardware |
|
| ||
GB - 9