Throttle Cable Installation
See Figure 8.
NOTE: The throttle control (Figure 15, Item 4) is mounted on the
1.Remove slotted hex cap screw and cable clamp from right side of engine.
2.Route throttle cable down between handlebar and wheel drive actuation link.
3.Loop end of cable up and back to engine throttle lever.
4.Install
5.Tilt cable upward until horizontal and position over clamp mount.
6.Install clamp over cable and attach to mount with slotted hex cap screw. Do not tighten cap screw.
7.Position throttle control (on handlebar) all the way forward (down) to the FAST position.
8.Push engine throttle lever fully forward until against its stop. The throttle lever may also be positioned against its stop by pulling the throttle cable froward.
9.Tighten the slotted hex cap screw to secure the clamp on the cable, securing the cable in place.
10.Install two cable ties to secure the OPC and throttle cables. See Figure 9.
•The upper tie secures both cables to the right side of the handlebar just below the support clamp.
•The lower tie is fed through the hole in the right side handlebar support to secure the throttle cable.
•Once secured, clip off excess ends of cable ties.
Throttle Cable Cable Clamp
Cable | Clamp Mount | |||
End | ||||
|
|
| ||
|
|
|
| |
|
|
|
| |
| Throttle |
|
|
| |
| Cable | Throttle Lever | Cap Screw | ||
2 | |||||
| |||||
|
|
| |||
|
|
|
| ||
|
|
|
| Handlebar | |
|
|
|
Throttle Lever | Cable |
|
Clamp | Cap Screw | |
|
|
Wheel Drive |
|
Throttle | |
Actuation Link | Cable |
Figure 8 |
|
GB - 11