11.Press the key. The machine will start an automatic descaling cycle with pauses programmed by the manufacturer and automatically managed by the machine.
The display will show:
MACHINE IS DESCALING
12.At the end of the cycle, dispensing of the descaling solution will stop and the display will show:
RINSE MACHINE
FILL WATERTANK
13. Rinse the water tank thoroughly and fill it with fresh drinking water.
14. Replace the tank and close the front panel.
The display will show:
RINSE MACHINE
PRESS WATER KEY
15. Place a suitably sized container below the steam spout and press the key.
Rinsing of the machine circuits begins and the display will show:
MACHINE IS RINSING
16.When the rinse cycle is complete, the display will show:
RINSING FINISHED
PRESS WATER KEY
17. Press the key; the display shows
CONNECT WATER NET
PRESS WATER KEY
18. Open the front
panel; remove the pipe NA from the tank connector.
19. Insert the pipe into the tank connector; close the front panel.
20. Press the key, reprime the circuits and leave the machine to heat up.
Interrupting the descaling cycle
If the descaling cycle is interrupted by the machine switching off, it is resumed when the machine is switched on again.
The descaling cycle may be interrupted by pressing the key; the display shows:
MACHINE IS DESCALING
INTERRUPTED
press the | key and the descaling cycle resumes. If | ||
the | key and the | key are pressed, the display | |
shows: |
|
|
|
DESCAL. INTERRUPTED
EMPTY WATERTANK
Warning! After the operation, empty the water tank of the descaling solution and wash it with fresh drinking water. The machine’s circuit must be washed with a rinse cycle.
Proceed as for a normal rinse cycle as described at point 13 of the previous chapter.
15