!Power Management [User Defined]
This item allows user to select system power saving mode.
Min Saving | Minimum power management. Suspend Mode=1 hr. |
Max Saving | Maximum power management. Suspend Mode=1 min. |
User Define | Allows user to set each mode individually. Suspend Mode= Dis- |
| abled or 1 min ~1 hr. |
!Video Off Method [DPMS]
This item allows user to determine the manner is which the monitor is blanked.
V/H SYNC+Blank | This option will cause system to turn off vertical and horizontal syn- |
| chronization ports and write blanks to the video buffer. |
Blank Screen | This option only writes blanks to the video buffer. |
DPMS | Initial display power management signaling. |
!Video Off In Suspend [Yes]
This item allows user to turn off Video when the system enters suspend mode.
!Suspend Type [Stop Grant]
This item allows user to determine the suspend type.
!Modem use IRQ [3]
This item allows user to determine the IRQ which the MODEM can use.
!Suspend Mode [Disabled]
Shows the time of system inactivity before all devices except the CPU will be shut off.
!HDD Power Down Mode [Disabled]
This item allows user to determine the time of system inactivity, the hard disk drive will be powered down.
!Soft-Off by PWR-BTTN [Instant-Off]
This item allows user to define function of power button.
Press power button then Power off instantly. | |
Delay 4 Sec | Press power button 4 sec. to Power off. |
!PWRON After PWR-Fail [ON/Off/Former-Sts]
Use this to set up the system after power failure. The “Off” setting keeps the sys- tem powered off after power failure, the “On” setting boots up the system after failure, and the
!PowerOn by LAN [Enabled]
This item allows users to power on the system via LAN. The choices are “Enabled” and “Disabled”.
!PowerOn by Modem [Enabled]
This item allows users to power on the system by Modem. The choices are “Enabled” and “Disabled”.
!USB KB Wake_Up From S3 [Disabled]
This item allows user to set USB keyboard wake up system from S3 Enable or Disable.
!PowerOn by Alarm [Disabled]
The choices are “Enabled” and “Disabled”. If enabled, the fields that follow indi- cate dates and times of alarm settings.
Chapter 2 BIOS Operation
41 |
