78
4.6.1 Console Commands Using the system console to upgrade the firmware is quite similar to using the Web management interface.
You must run the TFTP server first. Y ou must also assign the IP addre ss of the TFTP server and filename
separately. After they are configured, issue a copy command to initiate the firmware upgrade. Y ou can also
combine three commands into one. Following these steps:
Step 1: Configure TFTP server and filename
a) Separate command:
1. PBX Gateway(config)# tftp server <ip-address | domain name>
2. PBX Gateway(config)# tftp filename <filename>
3. PBX Gateway(config)# exit
4. PBX Gateway# copy tftp:///
b)Combined command
copy tftp://<ip-address>/<filename>
PBX Gateway(config)#copy tftp://192.168.0.201/a:\runtime.tcw
TFTP Server: 192.168.0.201
a:\runtime.tcw
Downloading….
Step 2: The Gateway should now be downloading the firmware. Wait for the result.
PBX Gateway(config)#copy tftp://192.168.0.201/a:\runtime.tcw
TFTP Server: 192.168.0.201
a:\runtime.tcw
Downloading....
Download success
System must reload
Step 3: If the gateway downloaded the firmware successfully, issue a cold-start to launch the new code.
PBX Gateway(config)#reload