2-16 Installing Asanté MacCon Cards
Installing in a Macintosh IIsi
To install the MacCon+ 30 or a MacCon3 IIsi in a Macintosh IIsi, per-
form the following steps:
Caution
Be very careful when you open the case and work inside the Mac-
intosh IIsi.
Refer to your Macintosh User’s Guide for an illustrated description of
how to open your computer.
1Power down the Macintosh. Disconnect and remove the
power cable.
2Open the Macintosh and remove the access port cover.
3Make sure you are grounded: check that your anti-static
wrist strap is properly attached to your wrist and to the
Macintosh chassis.
4Plug the controller card into the expansion slot on the
motherboard.
5Install the daughter card:
— Remove the screws on the daughter card bracket.
— Align the bracket so that the daughter card extends
down from the access port and the external cable con-
nectors protrude through the port.
— Secure the bracket with the screws.
6Connect the controller card and daughter card:
— Attach the ribbon cable from the daughter card to the
controller card (see Figure 2-12).
Caution
Make sure the white dot on the ribbon cable aligns with the
white dot on the connector.
7Close the Macintosh IIsi.
!
!