Manuals / Brands / Computer Equipment / Network Card / Asante Technologies / Computer Equipment / Network Card

Asante Technologies ASANTE MacCon Family Ethernet Network Cards for the Macintosh 1, 2, 1 2, 3

1 65

Download 65 pages, 711.2 Kb

Installing Asanté MacCon Cards 2-25

1Connect the “T” connector to the BNC port on the card. The

connector slips on, twists, and locks in place.

2If the Macintosh is the last node, terminate one end of the

“T” connector using a 50-ohm BNC terminator (for thin ca-

ble).

With thick Ethernet cabling

1Connect a drop cable to the thick Ethernet cable:

2Plug one end of the drop cable into the AUI port on the

card.

3Plug the other end into the thick Ethernet transceiver.

Installing the EtherTalk Software

An EtherTalk Installer diskette is included with each Asanté MacCon

Ethernet adapter. This diskette contains Asanté’s EtherTalk driver,

AppleTalk, and other Apple system extensions. Asanté’s EtherTalk

device driver allows AppleTalk to communicate with the MacCon

adapter.

Two Types of Software Installations

Asanté provides two types of installations–an easy install or a cus-

tomize install. You should be e xperienced in network administration

to perform the customize install.

For detailed information about each installation, click the Help but-

ton to display a help screen.

Contents

Main Page Page Page Asking for assistance Technical support hours Tell us what you think Table of Contents Page List of Figures Chapter 1 and Introducing the Asant MacCon Cards Summary of MacCon Card Features The Math Co-processor Option Asant EtherTalk Installer Software Installing Asant MacCon Cards Checking the Requirements Preparing for the Installation Observing the Safety Rules The MacCon NuBus Card Installing the MacCon NuBus Card Page Installing the MacCon 610 Card Page Page Installing a MacCon LC Card Page Page Page Installing the MacCon3 IIsi and MacCon 30i Cards Setting the Cable Type on the Daughter Card Video Options Setting the Slot Address for Two Cards Installing the Math Co-processor Installing in a Macintosh IIsi 1 2 3 4 5 6 Page Page Page 3 4 5 6 7 Installing a MacCon+ SE Card in a Macintosh SE Setting the Cable Type on the Daughter Card 1 2 3 4 5 6 7 8 9 10 11 12 Connecting the Macintosh to the Network 1 2 1 2 3 Installing the EtherTalk Software 1 2 3 4 5 Accessing Network Services 1 2 3 4 5 Chapter 3 IP Addressing Asant SNMP MacAgent Introduction Requirements Asant SNMP MacAgent and the TCP/IP Protocol Accessing Asant MacAgent MIB AsantView In-Band Network Management Software Installing SNMP MacAgent Page Conguring SNMP MacAgent Asant SNMP Conguration Parameters AsantView Network Management Station Other Network Management Software Chapter 4 Changing from EtherTalk to LocalTalk Using TroubleShooter and ADLS Diagnostic Software Running TroubleShooter Diagnostics Starting TroubleShooter Diagnostics Page Page Page If a test fails Page Page Chapter 5 Troubleshooting Running TroubleShooter Macintosh IIsi with a PDS Slot Installing the Math Co-processor Option Other Tips Page Page Appendix A The specications for the Asant MacCon cards are given below. MacCon Specications 23 2 Technical Specications Ethernet Address MacCon LEDs The table below lists the Ethernet specications. Ethernet Specications Connector Pin-outs AAUI Connector The following table describes the AUI connector pinouts. RJ-45 Connector