2.11 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!
FDD connector
(see p.12 No. 33)
the
Note: Make sure the
Serial ATAII Connectors
(SATA2_2: see | p.12, No. 15) | SATA2_2 | SATA2_3 |
(SATA2_3: see | p.12, No. 16) | ||
|
| ||
(SATA2_4: see | p.12, No. 17) | SATA2_4 | SATA2_5 |
(SATA2_5: see | p.12, No. 18) | ||
|
|
Serial ATA3 Connectors
(SATA3_0: see p.12, No. 13) | M1 | M2 |
(SATA3_M1: see p.12, No. 11) | _ | _ |
SATA3 | SATA3 | |
(SATA3_1: see p.12, No. 14) |
|
|
(SATA3_M2: see p.12, No. 12) | 0 | 1 |
| SATA3_ | SATA3_ |
Serial ATA (SATA)
Data Cable
(Optional)
Serial ATA (SATA)
Power Cable
(Optional)
connect to the SATA HDD power connector
connect to the power supply
These four Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate.
These four Serial ATA3 (SATA3) connectors support SATA data cables for internal storage devices. The current SATA3 interface allows up to 6.0 Gb/s data transfer rate. If you install the HDD on the eSATA port on the rear I/O, the internal SATA3_M2 will not function.
Either end of the SATA data cable can be connected to the SATA / SATAII / SATA3 hard disk or the SATAII / SATA3 connector on this motherboard.
Please connect the black end of SATA power cable to the power connector on each drive. Then connect the white end of SATA power cable to the power connector of the power supply.
33
